Auxiliary Equipment

Transfer Carts with are specially built gravity roll conveyors designed to easily transfer a stack of doors from the scissors lift to the press. Each cart is supported on four rigid casters that roll on floor-mounted steel tracks. Two casters are “V” grooved and ride on an inverted angle iron track to keep the loads properly aligned with the presses. A side-mounted handle allows the operator to move the load without disturbing the stack. “Pockets” are provided to allow the stack to be lifted off with a fork truck, if desired.

PRODUCT BULLETINS

Scissors lifts – either plain or with roller deck – are required for each lay-up station. Incorporating a gravity roll conveyor on the lift deck provides easier stack movement. This arrangement is equipped with a brake to keep the rolls from turning, enabling a stack of doors to be assembled on a caul board placed on the conveyor. A foot control allows the operator to lower the lift as the stack is being assembled, then raise the load to place it on the transfer cart. The entire arrangement is recessed into a floor pit to maintain a convenient working height for the operators.

PRODUCT BULLETINS

Inclined Outfeed Tables are constructed of a rigid sheet of UHMW polyethylene mounted on a metal frame equipped with adjusting legs. This allows the table to slope upward about 10″ (254 mm) from front to back. As material exits the adhesive spreader, the leading edge travels up the table without disturbing the glue on the bottom of the piece.