775 Single Top Hot Melt Glue Spreader

Description:

Application: To apply Reactive Hot Melt Adhesive or PUR to the top surface of Substrate at temperatures up to 350 Degrees F.

Nominal Length: 68″. Standard Pass Line Height: 30″ Upper Elevator: 0 to 4-1/2″ opening. Top Exhaust 8″ Outlet. Operating Controls and Hand-wheels: left end

Motorized Auto-Elevator with Encoder: Operator interface terminal in control panel w/ speed and roll opening display.

Doctor Roll and Coating Roll heated by rotary joint: with counter-flow on one end

Single Hand-wheel Doctor Roll Adjustment – Hand-wheel perpendicular to direction of flow includes mechanical digital read-out in .001″ increments

Independent Drive on Doctor Roll A.C. Inverter 2-20FPM

Variable Speed Drive: A.C Inverter Type, 30-90 FPM with 3″ Reverse Lock-out

Centralized Lubrication Manifolds: elevating gear boxes and bearings.

NEMA 12 Enclosure with main power disconnect switch and over-current protection: 460 Volt, 3 Phase, 60 Hertz, 24 VDC Control Circuits

Premium Teflon® Coating: guards, tables, end seal backing plates. Solid High Temp End Seals: with auxiliary end seal insert

Electric Oil Heat Transfer System: With Centrifugal Pump Mounted on Common Base: with separate controls for oil heater on right end. Filled and factory tested with heat transfer oil

775 SINGLE TOP HOT MELT GLUE SPREADER